Search  
TRACE HEATING

Parallel Circuit Heating Cable

Parallel circuit heating tracer is supplied with a constant wattage output of 30 and 40 Watt per meter at any required length not exceeding 60 meters. The tracer incorporates twin silicone insulated conductors with a spiral wound Nichrome element connected to the conductor at 1 000 mm intervals. The outer jacket is either extruded silicone or Teflon FEP flouropolymer resin. Specifically designed for process temperature compensation applications such as freeze protection, heating of pipe-lines, valves, pumps, etc. The tracer must always be temperature regulated either through a mechanical switching device (thermostat) or an electric switching device (controller). Maximum application temperature output varies between 120 - 150° C depending on tracer selection.

 

Self-Regulating Heating Cable

Similar in design to parallel heat tracer but supplied in a variety of wattages ranging from 25 Watt per meter to 65 Watt per meter at any required length not exceeding 60 meters. This tracer is designed to self-regulate and no additional temperature control is required. Maximum application temperature output is around 100° C but depends on the tracer selection.

 

FG CORD - Glass Fibre Heating Cord

FG CORD is a single core heating tracer with various output capabilities ranging from 25 - 150 Watt per meter and can be supplied to a maximum application length of 50 meters. The heat tracer consists of either a single core or multi stranded Nichrome wire core with termination on either end. The outer insulating jacket is a glass fibre overbraid suitable for high temperature applications and environments. Termination is normally on either end of the trace heater but can also be supplied on one side with an additional glass overbraid if required. Designed for process temperature compensation in applications such as freeze protection, heating of pipelines, valves, pumps, containers, heating mats etc. The tracer must always be temperature controlled and this can be done either with a mechanical switching device - (thermostat) or an electronic switching device (thermocouple and controller). Maximum application temperature limit: 400° C.

Copyright © Hi-Tech Elements    Telephone: +27 (0)11 894 3937 / 1077 | Fax: +27 (0)11 894 3954 | Email:

Terms & Conditions | Privacy Policy